U.S. DEPARTMENT OF COMMERCE National Oceanic and Atmospheric Administration National Ocean Service Datums Page Page 1 of 5 Station ID: 8678322 PUBLICATION DATE: 03/11/2013 Name: BAILEY CUT, SATILLA RIVER GA NOAA Chart: 11504 Latitude: 30° 59.1' N ( 30.98500) USGS Quad: KINGSLAND NE Longitude: 81° 35.5' W ( -81.59170) From the post office in Woodbine, GA, continue 0.18 km (0.1 mi) north in Bedell Avenue to the public boat ramp, proceed by boat 21.2 km (13.2 nm) east along the Satilla River to the entrance of Bailey Cut. The bench marks are located in the land strip to the left of the entrance of Bailey Cut. The tide gauge is located 3.05 m (10.0 ft) offshore of the land strip. T I D A L B E N C H M A R K S PRIMARY BENCH MARK STAMPING: 8322 A 2012 DESIGNATION: 867 8322 A MONUMENTATION: Metal Rod VM#: 20390 AGENCY: National Ocean Service (NOS) IDB PID#: SETTING CLASSIFICATION: Stainless steel rod in sleeve OPUS PID#: BBCR21 LATITUDE: 31° 1.2' N ( 31.01978) LONGITUDE: 81° 39.0' W ( -81.65050) The primary bench mark is a metal rod located 54.89 m (180.1 ft) NE of bench mark 867 8322 B, 23.20 m (76.1 ft) west of the shoreline, and 2.41 m (7.9 ft) east of the east edge of a woods. The datum point is set 15 cm ( 0.5 ft) above the ground, being the top of a stainless steel rod driven 11 m (36 ft) to refusal and encased in a 5-inch NOS logo cap.
U.S. DEPARTMENT OF COMMERCE National Oceanic and Atmospheric Administration National Ocean Service Page 2 of 5 Station ID: 8678322 PUBLICATION DATE: 03/11/2013 Name: BAILEY CUT, SATILLA RIVER GA NOAA Chart: 11504 Latitude: 30° 59.1' N ( 30.98500) USGS Quad: KINGSLAND NE Longitude: 81° 35.5' W ( -81.59170) T I D A L B E N C H M A R K S BENCH MARK STAMPING: 8322 B 2012 DESIGNATION: 867 8322 B MONUMENTATION: Metal Rod VM#: 20391 AGENCY: National Ocean Service (NOS) IDB PID#: SETTING CLASSIFICATION: Stainless steel rod in sleeve OPUS PID: LATITUDE: 31° 0.2' N ( 31.00267) LONGITUDE: 81° 39.1' W ( -81.65089) The bench mark is a metal rod located 55.81 m (183.1 ft) NE of bench mark 876 8322 C, 54.89 m (180.1 ft) SW of bench mark 867 8322 A, 26.79 m (87.9 ft) west of the shoreline, and 2.41 m (7.9 ft) east of the east edge of the woods. The bench mark is set 20 cm (0.5 ft) above the ground, being the top of a stainless steel rod driven 11.0 m (36 ft) to refusal and encased in a 5-inch NOS logo cap. BENCH MARK STAMPING: 8322 C 2012 DESIGNATION: 867 8322 C MONUMENTATION: Metal Rod VM#: 20392 AGENCY: National Ocean Service (NOS) IDB PID#: SETTING CLASSIFICATION: Stainless steel rod OPUS PID: LATITUDE: 31° 0.1' N ( 31.00231) LONGITUDE: 81° 39.1' W ( -81.65131) The bench mark is a metal rod located 155.81 m (511.2 ft) SW of bench mark 867 8322 B, 55.50 m (182.1 ft) NE of bench mark 867 8322 D, 42.09 m (138.1 ft) west of the shoreline, 2.41 m (7.9 ft) east of the east edge of the woods. The bench mark is set 15 cm (0.5 ft) above the ground, being the top of a stainless steel rod driven 11 m (36 ft) to refusal and encased in 5-inch NOS logo cap.
U.S. DEPARTMENT OF COMMERCE National Oceanic and Atmospheric Administration National Ocean Service Page 3 of 5 Station ID: 8678322 PUBLICATION DATE: 03/11/2013 Name: BAILEY CUT, SATILLA RIVER GA NOAA Chart: 11504 Latitude: 30° 59.1' N ( 30.98500) USGS Quad: KINGSLAND NE Longitude: 81° 35.5' W ( -81.59170) T I D A L B E N C H M A R K S BENCH MARK STAMPING: 8322 D 2012 DESIGNATION: 867 8322 D MONUMENTATION: Metal Rod VM#: 20393 AGENCY: National Ocean Service (NOS) IDB PID#: SETTING CLASSIFICATION: Stainless steel rod OPUS PID: LATITUDE: 31° 0.1' N ( 31.00200) LONGITUDE: 81° 39.1' W ( -81.65181) The bench mark is a metal rod located 59.41 m (194.9 ft) NE of bench mark 867 8322 E, 55.50 m (182.1 ft) SW of bench mark 867 8322 C, 2.41 m (7.9 ft) SE of the east edge of the woods. The bench mark is set 15 cm (0.5 ft) above the ground, being the top of a stainless steel rod driven 11 m (36 ft) to refusal and encased in a 5-inch NOS logo cap. BENCH MARK STAMPING: 8322 E 2012 DESIGNATION: 867 8322 E MONUMENTATION: Metal Rod VM#: 20394 AGENCY: National Ocean Service (NOS) IDB PID#: SETTING CLASSIFICATION: Stainless steel rod OPUS PID: LATITUDE: 31° 0.1' N ( 31.00175) LONGITUDE: 81° 39.1' W ( -81.65231) The bench mark is a metal rod located 59.41 m (194.9 ft) WSW of bench mark 867 8322 D, 2.41 m (7.9 ft) SE of the east edge of the woods, and 2.01 m (6.6 ft) WNW of the highwater mark along the shoreline. The bench mark is set 15 cm (0.5 ft) above the ground, being the top of a stainless steel rod driven 11 m (36 ft) to refusal and encased in a 5-inch NOS logo cap.
U.S. DEPARTMENT OF COMMERCE National Oceanic and Atmospheric Administration National Ocean Service Page 4 of 5 Station ID: 8678322 PUBLICATION DATE: 03/11/2013 Name: BAILEY CUT, SATILLA RIVER GA NOAA Chart: 11504 Latitude: 30° 59.1' N ( 30.98500) USGS Quad: KINGSLAND NE Longitude: 81° 35.5' W ( -81.59170) T I D A L D A T U M S Tidal datums at BAILEY CUT, SATILLA RIVER based on: LENGTH OF SERIES: 3 MONTHS TIME PERIOD: October 2012 - December 2012 TIDAL EPOCH: 1983-2001 CONTROL TIDE STATION: 8720030 FERNANDINA BEACH, AMELIA RIVER Elevations of tidal datums referred to Mean Lower Low Water (MLLW), in METERS: MEAN HIGHER HIGH WATER MHHW = 2.227 MEAN HIGH WATER MHW = 2.140 MEAN SEA LEVEL MSL = 1.197 MEAN TIDE LEVEL MTL = 1.104 MEAN LOW WATER MLW = 0.069 MEAN LOWER LOW WATER MLLW = 0.000 North American Vertical Datum (NAVD88) Bench Mark Elevation Information In METERS above: Stamping or Designation MLLW MHW 8322 A 2012 2.474 0.334 8322 B 2012 2.539 0.399 8322 C 2012 2.571 0.431 8322 D 2012 2.520 0.380 8322 E 2012 2.446 0.306
U.S. DEPARTMENT OF COMMERCE National Oceanic and Atmospheric Administration National Ocean Service Page 5 of 5 Station ID: 8678322 PUBLICATION DATE: 03/11/2013 Name: BAILEY CUT, SATILLA RIVER GA NOAA Chart: 11504 Latitude: 30° 59.1' N ( 30.98500) USGS Quad: KINGSLAND NE Longitude: 81° 35.5' W ( -81.59170) D E F I N I T I O N S Mean Sea Level (MSL) is a tidal datum determined over a 19-year National Tidal Datum Epoch. It pertains to local mean sea level and should not be confused with the fixed datums of North American Vertical Datum of 1988 (NAVD88). NAVD88 is a fixed datum derived from a simultaneous, least squares, minimum constraint adjustment of Canadian/Mexican/United States leveling observations. Local mean sea level observed at Father Point/Rimouski, Canada was held fixed as the single initial constraint. NAVD88 replaces NGVD29 as the national standard geodetic reference for heights. Bench mark elevations relative to NAVD88 are available from NGS through the World Wide Web at National Geodetic Survey. NGVD29 is a fixed datum adopted as a national standard geodetic reference for heights but is now considered superseded. NGVD29 is sometimes referred to as Sea Level Datum of 1929 or as Mean Sea Level on some early issues of Geological Survey Topographic Quads. NGVD29 was originally derived from a general adjustment of the first-order leveling networks of the U.S. and Canada after holding mean sea level observed at 26 long term tide stations as fixed. Numerous local and wide-spread adjustments have been made since establishment in 1929. Bench mark elevations relative to NGVD29 are available from the National Geodetic Survey (NGS) data base via the World Wide Web at National Geodetic Survey. NAVD88 and NGVD29 are fixed geodetic datums whose elevation relationships to local MSL and other tidal datums may not be consistent from one location to another. The Vertical Mark Number (VM#) and PID# shown on the bench mark sheet are unique identifiers for bench marks in the tidal and geodetic databases, respectively. Each bench mark in either database has a single, unique VM# and/or PID# assigned. Where both VM# and PID# are indicated, both tidal and geodetic elevations are available for the bench mark listed. The NGS's Integrated Data Base (IDB PID) provides geodetic datum based on traditionally leveled and bluebooked ties to the National Spatial Reference System(NSRS) https://www.ngs.noaa.gov/datasheets/. The NGS Online Positioning User Service (OPUS PID) provides geodetic datum based on GPS position & tie it to the NSRS https://www.ngs.noaa.gov/OPUS/. The NAVD88 elevation is shown on the Elevations of Tidal Datums Table Referred to MLLW only when two or more of the bench marks listed have NAVD88 elevations. The NAVD88 elevation relationship shown in the table is derived from an average of several bench mark elevations relative to tide station datum. As a result of this averaging, NAVD88 bench mark elevations computed indirectly from the tidal datums elevation table may differ slightly from NAVD88 elevations listed for each bench mark in the NGS database.